Motor replacement for properties in Jarrow
If your address has an NE32 postcode, it falls within our Tyne and Wear coverage. We also carry out roller shutter motor replacement in Hebburn, Wallsend and South Shields.
Jarrow sits some 5 miles to the east of Newcastle upon Tyne.
We work on most makes of domestic, shop and industrial shutter in Jarrow, including ones fitted by other companies.
A motor that hums but does not turn, a shutter that stops part-way or a remote that has stopped working can all be diagnosed on site in Jarrow.
What the work can involve
The work usually involved in Jarrow:
- IndustrialDirect-drive gear motors with emergency hand operation.
- DomesticTubular motors for window, door and garage shutters.
- ShopTube motors or external drives with key switch.
Guide prices for roller shutter motor replacement in Jarrow
| Roller shutter motor replacement | Inc VAT | Ex VAT |
|---|---|---|
| Domestic tubular motor | £295 – £595 | £245 – £495 |
| Shop or commercial tube motor | £715 – £1,435 | £595 – £1,195 |
| Industrial side-mounted gear motor | £1,075 – £2,275 | £895 – £1,895 |
Guide prices, per motor, supplied and fitted. VAT at 20% where it applies.
Guide prices only: the make, size and condition of your shutter decide the final figure, and nothing beyond the visit is done without your say-so.
Rules that apply in Jarrow
As an English town, Jarrow follows the Town and Country Planning Act 1990 and the permitted development rules in England.
- Electrical work: Motors are wired to BS 7671; any change to the supply is done by a qualified electrician.
From enquiry to finished job
Describe the problem
What the shutter is doing, what it is made of and roughly when it was fitted, with photos if possible.
Visit and diagnosis
An engineer checks the shutter, finds the cause and explains the options.
Cost agreed first
Anything beyond the visit is priced and agreed with you before the work is done.
Fixed and reported
We complete the work, test the shutter and leave a short written report.
Questions about roller shutter motor replacement in Jarrow
Can I replace the motor without replacing the shutter?
Yes, in most cases. The motor slides out of the barrel or unbolts from the side.
How do I know if my shutter motor has failed?
If the shutter hums but does not move, stops part way, or does nothing when the power and switch are fine, the motor or its limits are the likely cause. We test before replacing.
Do you charge for a visit in Jarrow?
Yes, visits for repairs and servicing are charged, and we tell you the cost before booking. New-installation surveys are free.
Do you cover Jarrow?
Yes, we carry out roller shutter motor replacement in Jarrow (NE32) as part of our Tyne and Wear coverage.